AC Infinity IONFRAME A7 Test, Review & Data Sheet

Link to the Data Sheet: IONFRAME A7 DATA SHEET

Use code EVYGROWS at: https://amzn.to/4eBbtTe or site direct: https://bit.ly/3T85Pj1

In this review, I test the AC Infinity IONFRAME A7 inside an AC Infinity 2×4 tent using the same testing setup I use in my grow light comparisons.

Grow Light Test Setup: https://amzn.to/4ag3E2U

PPFD’s tested at 18 inches from the light Temperature probe placed 12 inches above the fixture Readings taken after stabilization

AC Infinity IONFRAME A7 test data:

LED count: 1,808 total LEDs 128 infrared LEDs Dimensions: 43 inches x 4.5 inches Power draw: Level 1: 140 watts Level 3: 251.1 watts Level 10 / 100%: 662 watts Level 10 PPFD at 18 inches: Top Left: 1470 Top Mid: 2205 Top Right: 1712 Bottom Left: 1510 Bottom Mid: 1933 Bottom Right: 1620 Level 3 PPFD at 18 inches: Top Left: 605 Top Mid: 875 Top Right: 679 Bottom Left: 600 Bottom Mid: 787 Bottom Right: 678 Seedling setting: To hit about 250 PPFD centered, place the light 38 inches away at Level 1, drawing around 140 watts. Spectrum data: Blue PFD: 257 Green PFD: 681 Red PFD: 1243 IR PFD: 498 Total PPFD: 2169 DLI: 93.7 The biggest takeaway is that this light does not need to be run at 100% for most growers. At Level 3, it only pulls around 251 watts while still producing PPFD numbers that match or beat many lights running closer to 300+ watts. That means better efficiency, lower heat, and potentially better long-term LED lifespan since you are not forced to run the fixture maxed out all the time. This is one of the most powerful 2×4 grow lights I’ve tested so far. For a discount on this light, use code EVYGROWS on the AC Infinity website or on Amazon for additional savings. Check out my full grow light review and comparison playlist for more real-world PPFD testing, power draw testing, spectrum readings, and heat-over-time comparisons. #ACInfinity #IONFRAMEA7 #GrowLightReview #BestGrowLight2026 #2x4GrowTent #LEDGrowLight #IndoorGrowing #PPFDTest #GrowLightComparison #GrowLights

Most grow lights marketed for a 2×4 tent seriously lack the coverage and intensity needed to fully maximize the space. A lot of newer lights are weaker than older models, have fewer diodes, and in many cases, you would probably need two lights to actually use the full canopy area properly. The  @acinfinity  IONFRAME A7 is the counterargument. This light is different from the typical panel lights and bar lights I’ve tested. It uses a thick aluminum heatsink body, a detached driver, spring-style hanging clips, and a massive diode count: 1,808 total LEDs, including 128 infrared LEDs.